THEORETICAL ANALYSIS OF LINED -DUCT SOUND ATTENUATION

Authors

  • Chris Bibby Acoustics and Noise Research Group, University of British Columbia
  • Murray Hodgson

Abstract

This paper investigates theoretically how duct geometry and liner thickness affect the attenuation of fundamental-mode
sound propagation in a lined duct. The study was done to satisfy the need for a greater understanding of interior natural-
ventilation openings and of silencers implemented to improve the acoustical performance (‘ventilators’), and to provide
engineers and architects with optimal-design guidelines. It assumed ventilators of the simplest form – straight, acoustically-
lined ducts of rectangular cross-section. An analytical solution is presented for the attenuation of the fundamental mode in
such a duct. Duct-liner thickness does not affect high-frequency performance; however, it limits low-frequency performance.
A 25-mm liner is likely not thick enough to be effective, but a 100-mm liner may be excessive. Increasing the duct height
reduces the attenuation at all frequencies; in order to provide effective attenuation through the 4000-Hz band, the height
should not exceed 100 mm. If the cross-sectional aspect ratio of a duct is greater than 10, or the duct is only lined on two
opposing surfaces, the attenuation of its fundamental mode is in effect identical to that of a 2D lined duct. Provided that the
duct liner and height are such that the silencer is effective at absorbing sound at a given frequency, reducing the aspect ratio
towards unity will result in large attenuation gains.

Downloads

Published

2014-01-30

How to Cite

1.
Bibby C, Hodgson M. THEORETICAL ANALYSIS OF LINED -DUCT SOUND ATTENUATION. Canadian Acoustics [Internet]. 2014 Jan. 30 [cited 2021 Dec. 8];41(3):15-22. Available from: https://jcaa.caa-aca.ca/index.php/jcaa/article/view/2625

Issue

Section

Article - Engineering Acoustics / Noise Control

Most read articles by the same author(s)

<< < 1 2 3 4 5 6 > >>