The Transmission Loss of Double Stud Walls with Layers of Gypsum Board Installed inside the Wall Cavity

Authors

  • Jeffrey Mahn National Research Council Canada
  • Sabrina Skoda National Research Council Canada
  • Iara Cunha National Research Council Canada https://orcid.org/0000-0001-7969-6618

Keywords:

Transmission loss

Abstract

A demising wall assembly that is frequently specified by architects for mid-rise to high-rise building constructions is a double steel stud, non-loadbearing wall assembly with one or more sheets of fire rated gypsum board installed inside the wall cavity between the rows of studs.  Locating the gypsum board inside the wall cavity can sharply decrease the transmission loss below the 200 Hz one-third octave band due to the creation of two mass-air-mass resonances centered around the 80 Hz one-third octave band.  One theory for why gypsum board is being specified inside the wall cavity is the belief that the gypsum board in the wall cavity maintains the transmission loss of the wall even if residents create small holes in the outer gypsum board layers by hanging decorations on the wall or securing furniture to the wall.  To disprove this theory, an increasingly larger number of holes were drilled into the gypsum board on both sides of a wall to determine the effect on the transmission loss.  It was found that a significant number of holes, well in excess of normal use of a wall needed to be drilled into the gypsum board before the transmission loss was affected.

Published

2024-09-08

How to Cite

1.
Mahn J, Skoda S, Cunha I. The Transmission Loss of Double Stud Walls with Layers of Gypsum Board Installed inside the Wall Cavity. Canadian Acoustics [Internet]. 2024 Sep. 8 [cited 2024 Oct. 6];52(3). Available from: https://jcaa.caa-aca.ca/index.php/jcaa/article/view/3976

Issue

Section

Article - Architectural Acoustics

Similar Articles

1 2 3 4 5 6 7 8 9 10 > >> 

You may also start an advanced similarity search for this article.